Machining
Faceplate Dogs
Last month I roughly sawed and filed my cast aluminium blobs into blocks. The resulting blocks were too large to fit into my 3 jaw chuck so I hoped to mount them on the faceplate. There are many ways of
Posted in: Face Plate Dogs, Lathe, Machining, Work Holding
Blobs to blocks 2
From my second cast, I produced the following two blobs. The left hand one was much better than previous attempts with a large section of straight sides and a better finish. I expect the right one would have been better
Posted in: Casting, Lathe, Machining
Materials: Aluminium
Tags: faceplate dogs, Metal Work
Machined blob
This weekend I machined up one the castings from last week’s melt. Here’s the stages from scrap to machined results. Step 1Some scrap ali that I found round the back of the shed, sawn up into suitable sized pieces to
Posted in: Casting, Lathe, Machining
Materials: Aluminium
Tags: Metal Work, Scrap
Metal sculpture in brass, mounted on an 1800s French Coin
