ATX Power Control Board

ATX Power Control Board

When I built the MING Pi, I needed a way to signal to the ATX power supply that it needed to turn on. I did that by cutting an ATX connector in half and soldering the Power On wire to

Continue reading Comments Add Comment

MakerSpace Magazine

MakerSpace Magazine

On a recent trip to the states, I dropped into Barnes and Noble to see if there were any interest magazines. And I was not disappointed. As well as finding a copy of Machinist’s Workshop with a differential chain hoist,

Continue reading Comments Add Comment

Pi and Chips

Pi and Chips

I’ve been working on another electronics video, as part of that I need a large Raspberry Pi logo. I looked online and there were some stickers but most of them were smaller than I wanted. So I decided to 3D

Continue reading Comments Add Comment

Pi4 Gotchas

Pi4 Gotchas

I’ve started a project based around a Raspberry Pi4 and thought I’d share some of the “gotchas” that I spotted and in some cases didn’t spot. Power The Pi4 is faster and more powerful than previous models. This means that

Continue reading Comments One Comment

Workshop Preparation

Workshop Preparation

In preparation for the Raspberry Pi workshop at the end of the month I’ve been experimenting with the Raspberry Pi and simple hardware. So far I’ve had success with: LED Micro switch Tilt switch Servo Motor via H-Bridge I’ve also

Continue reading Comments Add Comment

Thinking about animatronics

Thinking about animatronics

I’ve been invited to a play workshop in Leeds at the end of the month and that in turn has got me thinking about animatronics. Basically we plan to make some gnomes and make them move. Two key factors here

Continue reading Comments Add Comment

Raspberry Pi 2 – Hands On Videos

The long awaited Raspberry Pi 2 has been launched today, it’s faster and has more ram than it’s predecessors so you’ll be able to more with it for the same price

Continue reading Comments Add Comment